Description
Sacema has the Round Brushes for Sealing Shafts, an innovation that is a solution for the treatment of shafts, tubes and cables.
It is a solution specifically designed as a collar or ring with filaments on the inside of it to seal and superficially treat the surfaces of tube or shaft-type parts that pass through the interior of the brush.
In addition, the Round Brushes are used to cover cylindrical holes using a special industrial brush curtain.
A very good solution for turning parts in which shafts and profiles of a certain length are worked, sealing the inlet and outlet of the machine against coolants, chips or lubricants, which in many occasions cause dirt on the outside of the machine and face. The part sensors are connected to the machine control system.
The system of Round Brushes for Sealing Shafts is available in 3 sizes or total diameters (85, 125 and 165 mm) which, with the appropriate filament configuration, cover shafts from 9 to 108 mm in diameter.
A sealing of the flexible shaft is obtained, although we have an interference by vibrations and a retention of a certain reliability.
In addition, this industrial brush for sealing shafts is the ideal solution if you want to effectively lubricate the entire surface of the shaft, if a lubrication system is installed on the brush, since the lubricant is distributed to the part through the filaments of the industrial brush.
It is delivered in batches of 20 units and has 3 fixing holes for the machine support.
Both the base and the filaments of the round brushes for sealing shafts are made of polyamide 6 (PA 6) so it has a high mechanical resistance and against industrial agents.
Another very common application of the industrial round brushes for sealing shafts is guiding the passage of cables in circular holes, so that they are not damaged by the edges of the housing.
If you have any questions or queries about the industrial cleaning, retention or about it, do not hesitate to contact us.