The Protection and Support Brushes have a very important advantage over other protection and support systems. The pieces rest on the filaments of the brushes, being a flexible support and therefore much softer and cleaner than other solutions.
If you still have any questions or queries about the Protection and Support Brushes, do not hesitate to contact us and we will respond as soon as possible.
We have 4 families of brushes for the protection and support brushes for delicate pieces:
1. Guard-System for 28mm tubes:
The 28 mm tube size is the most common and used for the manufacture of tubular frames, workstations and storage and transport systems for delicate parts.
They are brushes for easy placement and removal without tools, with two possible configurations: dense or light.
2. Prism seats:
An industrial brush system for the protection and support of delicate parts by prism seats.
Especially practical for storing profiles and delicate slats since they only rest on the brush filaments, facilitating the sliding of stored products. Available in 2 sizes depending on the diameter of the pieces.
3. Parts support for transportation:
A set of solutions for the transportation, fixing and support of all kinds of parts. It is the only way for holding delicate parts for transportation to ensure that they are fit securely, cushioned, supported and handled while kept clean.
We have specific industrial brushes for protection, guidance and support for fixing on the wall behind the pieces, on the floor, on the side walls, as well as the protection of the front edge.
4. U Support:
An industrial brush for protection with a special U-shape. Strands are inserted to it on both sides to ensure avoiding damage to the parts during storage and positioning.
They are individually fixed to the base according to the needs of each case with frames of 75, 120 and 190 mm length.